Essential components

Every CNC machine from the lowest cost and smallest to the largest shipyard machine must have some form of the following components.

• CNC control. The brains of the entire machine, converts cutting program into electrical signals that direct the direction and speed that the machine cuts at. Also signals the plasma cutter, height control and other peripherals how and when to operate.

• Mechanical components. Each machine has to have moving components such as a gantry (long axis), a torch carriage and a Z-axis (up and down) that manipulate and move the plasma torch to produce the cut parts desired.

• Fume Control System. Plasma cutting generates a lot of fumes and smoke. Every machine requires either a downdraft fume control or a water table control.

Brief Introduction:
1. The CNC flame cutting machine is guide rail fixed, gantry gate move type;
2. The flame cutting guns will cut carbon steel;
3. Cross arm operation accuracy is within 0.5mm/m;
4. Oxy and acetylene or oxy and acetonum gas as fuel source;
5. Guide rail length is 15M*2PCS;
6. X axis Panasonic servo and pilot reducer driven, Y axis Panasonic servo and pilot reducer driven;
7. CNC system: Beijing SH-2000.

Supply scope:
Frame unit: Beam, pipe, broadwise beam and longitude and broadwise reducer and etc.
Track unit: Guide and accessories. The guide size is 14m*2PCS.
Cutting torch unit: Linear single cutting gun*10PCS and accessories.
Electric control system: Electric control cabinet, longitude and broadwise motors and accessories.
Gas source unit: Main air rubber pipe, suspending sliding vehicle and etc.

You may interest in other products: